Search results
Results from the WOW.Com Content Network
A raised aileron reduces lift on that wing and a lowered one increases lift, so moving the aileron control in this way causes the left wing to drop and the right wing to rise. This causes the aircraft to roll to the left and begin to turn to the left. Centering the control returns the ailerons to the neutral position, maintaining the bank angle ...
The natural outcome of this requirement is a wing design that is thin and wide, which has a low thickness-to-chord ratio. At lower speeds, undesirable parasitic drag is largely a function of the total surface area , which suggests using a wing with minimum chord, leading to the high aspect ratios seen on light aircraft and regional airliners .
It is common practice to derive a fourth order characteristic equation to describe the longitudinal motion, and then factorize it approximately into a high frequency mode and a low frequency mode. The approach adopted here is using qualitative knowledge of aircraft behavior to simplify the equations from the outset, reaching the result by a ...
Pairs of ailerons are typically interconnected so that when one is moved downward, the other is moved upward: the down-going aileron increases the lift on its wing while the up-going aileron reduces the lift on its wing, producing a rolling (also called 'banking') moment about the aircraft's longitudinal axis (which extends from the nose to the ...
Equations for divergence of a simple beam Divergence can be understood as a simple property of the differential equation(s) governing the wing deflection. For example, modelling the airplane wing as an isotropic Euler–Bernoulli beam, the uncoupled torsional equation of motion is = ′,
A wing of infinite span and uniform airfoil segment (or a 2D wing) would experience no induced drag. [11] The drag characteristics of a wing with infinite span can be simulated using an airfoil segment the width of a wind tunnel. [12] An increase in wingspan or a solution with a similar effect is one way to reduce induced drag.
Also, longer wings may have some torsion for a given load, and in some applications this torsion is undesirable (e.g. if the warped wing interferes with aileron effect). Maneuverability : a low aspect-ratio wing will have a higher roll angular acceleration than one with high aspect ratio, because a high aspect-ratio wing has a higher moment of ...
The lower/nearer the wing is to the ground, the more pronounced the ground effect becomes. While in the ground effect, the wing requires a lower angle of attack to produce the same amount of lift. In wind tunnel tests, in which the angle of attack and airspeed remain constant, an increase in the lift coefficient ensues, [ 9 ] which accounts for ...