Search results
Results from the WOW.Com Content Network
The gateway address must be configured on each host. The network host IP interface binds the gateway address to the MAC address of the physical gateway by broadcasting IP datagrams and caching the MAC address of the reply from the gateway in an ARP table stored on the host. The gateway address may be added manually.
The IP-address could be 91.198.174.2. In this example, none of the internal routers know the route to that host, so they will forward the packet through router1's gateway or default route. [1] Every router on the packet's way to the destination will check whether the packet's destination IP-address matches any known network routes. If a router ...
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
The Interface indicates what locally available interface is responsible for reaching the gateway. In this example, gateway 192.168.0.1 (the internet router) can be reached through the local network card with address 192.168.0.100. Finally, the Metric indicates the associated cost of using the indicated route. This is useful for determining the ...
A discover request is sent via HTTP and port 1900 to the IPv4 multicast address 239.255.255.250 (for the IPv6 addresses see the Simple Service Discovery Protocol (SSDP)): M-SEARCH * HTTP/1.1 HOST: 239.255.255.250:1900 MAN: "ssdp:discover" MX: 2 ST: urn:schemas-upnp-org:device:InternetGatewayDevice:1
CIADDR (Client IP address: 0x00000000) 44 352 YIADDR (Your IP address: 0xC0A80164 or 192.168.1.100) 48 384 SIADDR (Server IP address: 0xC0A80101 or 192.168.1.1) 52 416 GIADDR (Gateway IP address: 0x00000000) 56 448 CHADDR (Client Hardware address: 0x00053C04 0x8D590000 0x00000000 0x00000000) 60 480 64 512 68 544 72 576
The access router gives the dial-up nodes IP addresses in the range 192.168.0.128 – 192.168.0.254; for this example, assume a dial-up node gets IP address 192.168.0.254. The access router uses proxy ARP to make the dial-up node present in the subnet without being wired into the Ethernet: the access router 'publishes' its own MAC address for ...
It is a six-byte field that is either the local assigned address (LAA) or universally assigned address (UAA) of the sending station adapter. Data – A variable length field of 0 or more bytes, the maximum allowable size depending on ring speed containing MAC management data or upper layer information.