Search results
Results from the WOW.Com Content Network
A transform fault or transform boundary, is a fault along a plate boundary where the motion is predominantly horizontal. [1] It ends abruptly where it connects to another plate boundary, either another transform, a spreading ridge, or a subduction zone. [2] A transform fault is a special case of a strike-slip fault that also forms a plate boundary.
Three types of plate boundary Convergent boundary Divergent boundary Transform boundary. Tectonic plate interactions are classified into three basic types: [1] Convergent boundaries are areas where plates move toward each other and collide. These are also known as compressional or destructive boundaries.
Transform faults are plate boundaries, meaning that on either side of the fault is a different plate. In contrast, outside of the ridge-ridge transform fault, the crust on both sides belongs to the same plate, and there is no relative motion along the junction. [3]
Strike-slip tectonics or wrench tectonics is a type of tectonics that is dominated by lateral (horizontal) movements within the Earth's crust (and lithosphere).Where a zone of strike-slip tectonics forms the boundary between two tectonic plates, this is known as a transform or conservative plate boundary.
The San Andreas Fault in California is an example of a transform boundary exhibiting dextral motion. Other plate boundary zones occur where the effects of the interactions are unclear, and the boundaries, usually occurring along a broad belt, are not well defined and may show various types of movements in different episodes.
Globally most fault zones are located on divergent plate boundaries on oceanic crust. This means that they are located around mid-ocean ridges and trend perpendicular to them. The term fracture zone is used almost exclusively for features on oceanic crust ; similar structures on continental crust are instead termed transform or strike slip faults .
At the triple junction each of the three boundaries will be one of three types – a ridge (R), trench (T) or transform fault (F) – and triple junctions can be described according to the types of plate margin that meet at them (e.g. fault–fault–trench, ridge–ridge–ridge, or abbreviated F-F-T, R-R-R).
There are three main types of faults: [1] normal faults, reverse faults and strike slip (transform) faults. All of these are ways the crust can deform is due to the different types of plate margins, which are: [2] divergent boundaries, convergent boundaries, and transform boundaries.