Search results
Results from the WOW.Com Content Network
Flame temperatures of up to 1,100–1,200 °C (2,000–2,200 °F) are achievable if properly used. The flame also burns without noise, unlike the Bunsen or Teclu burners. [11] Tirrill burner – The base of the burner has a needle valve which allows the regulation of gas intake directly from the burner, rather than from the gas source. Maximum ...
Propane burner with a Bunsen flame Oxy-Acetylene for cutting through steel rails Flame of a gas and oil, in a dual burner. A gas burner is a device that produces a non-controlled flame by mixing a fuel gas such as acetylene, natural gas, or propane with an oxidizer such as the ambient air or supplied oxygen, and allowing for ignition and ...
The first gas heater made use of the same principles as the Bunsen burner. Beginning in 1881, the burner's flame was used to heat a structure made of asbestos, a design patented by Sigismund Leoni, a British engineer. Later, fire clay replaced the asbestos because it is easier to mold.
Flat burners were invented mainly to distribute gas and light evenly to the systems. The fishtail burner was similar to the flat burner, but it produced a brighter flame and conducted less heat. The last burner that was experimented with was the Welsbach burner. Around this time the Bunsen burner was in use along with some forms of electricity ...
A gas cylinder quad, also known as a gas cylinder bundle, is a group of high pressure cylinders mounted on a transport and storage frame. There are commonly 16 cylinders, each of about 50 litres capacity mounted upright in four rows of four, on a square base with a square plan frame with lifting points on top and may have fork-lift slots in the ...
For this work, Bunsen and his laboratory assistant, Peter Desaga, had perfected a special gas burner by 1855, which was influenced by earlier models. The newer design of Bunsen and Desaga, which provided a very hot and clean flame, is now called simply the "Bunsen burner", a common laboratory equipment. [16] [17]
It is often used in incubators and as a replacement for rubber tubing for Bunsen burners. This material is produced in vacuum sizes and can withstand a full vacuum at room temperature. It is a thermoplastic PVC-based material with plasticizer. [3] Tygon R-1000 Ultra-Soft Tubing is used in general laboratory applications.
Test tubes are convenient containers for heating small amounts of liquids or solids with a Bunsen burner or alcohol burner. The tube is usually held by its neck with a clamp or tongs. By tilting the tube, the bottom can be heated to hundreds of degrees in the flame, while the neck remains relatively cool, possibly allowing vapours to condense ...