Ad
related to: transistor collector current calculation
Search results
Results from the WOW.Com Content Network
The common collector amplifier's low output impedance allows a source with a large output impedance to drive a small load impedance without changing its voltage. Thus this circuit finds applications as a voltage buffer. In other words, the circuit has current gain (which depends largely on the h FE of the transistor) instead of voltage gain. A ...
Bipolar transistors can be considered voltage-controlled devices (fundamentally the collector current is controlled by the base–emitter voltage; the base current could be considered a defect and is controlled by the characteristics of the base–emitter junction and recombination in the base).
For a typical current of 10 mA, g m ≈ 385 mS. The input impedance is the current gain (β) divided by the transconductance. The output (collector) conductance is determined by the Early voltage and is proportional to the collector current. For most transistors in linear operation it is well below 100 μS.
The transistor can be biased so that its collector is normally less than half of the power supply voltage, which implies that collector–emitter power dissipation is at its maximum value. Runaway is then impossible because increasing collector current leads to a decrease in dissipated power; this notion is known as the half-voltage principle.
Early, is the variation in the effective width of the base in a bipolar junction transistor (BJT) due to a variation in the applied base-to-collector voltage. A greater reverse bias across the collector–base junction, for example, increases the collector–base depletion width, thereby decreasing the width of the charge carrier portion of the ...
Using a cascode configuration, which inserts a low input impedance current buffer (e.g. a common base amplifier) between the transistor's collector and the load. This configuration holds the transistor's collector voltage roughly constant, thus making the base to collector gain zero and hence (ideally) removing the Miller effect.
In a circuit with a three terminal device, such as a transistor, the current–voltage curve of the collector-emitter current depends on the base current. This is depicted on graphs by a series of (I C –V CE) curves at different base currents. A load line drawn on this graph shows how the base current will affect the operating point of the ...
Consider an NPN transistor circuit. During the positive half-cycle of the signal, the base is positive with respect to the emitter and hence the base-emitter junction is forward biased. This causes a base current and much larger collector current to flow. The positive half-cycle of the signal is amplified in the collector.
Ad
related to: transistor collector current calculation