enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Printed circuit board manufacturing - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board...

   Printed circuit board manufacturing is the process of manufacturing bare printed circuit boards (PCBs) and populating them with electronic components. It involves the full assembly of a board into a functional circuit board. In board manufacturing, multiple PCBs are grouped on a single panel for efficient processing.

3. Stencil printing - Wikipedia

   en.wikipedia.org/wiki/Stencil_Printing

   The stencil and board are then separated and unloaded. The bottom of the stencil is wiped about every ten prints to remove excess solder paste remaining on the stencil. A typical printing operation has a speed of around 15 to 45 seconds per board. Print head speed is typically 1 to 8 inches per second. The printing process must be carefully ...

4. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   Not to be confused with Printed electronics. "PC board" redirects here. For the mainboard of personal computers, see Motherboard. "Panelization" redirects here. For the page layout strategy, see N-up. Printed circuit board of a DVD player Part of a 1984 Sinclair ZX Spectrum computer board, a printed circuit board, showing the conductive traces, the through-hole paths to the other surface, and ...

5. TTM Technologies - Wikipedia

   en.wikipedia.org/wiki/TTM_Technologies

   TTM Technologies, Inc. was founded in 1998 by Kent Alder in Redmond, Washington, [3] via an acquisition of Pacific Circuits, Inc., and moved to Santa Ana, California, in 1999, after acquiring Power Circuits, Inc. [4] Alder was previously the president of Lundahl Astro Circuits, Inc. in Logan, Utah, from 1987, and president and CEO of its successor ElectroStar, Inc. from 1994.

6. Component placement - Wikipedia

   en.wikipedia.org/wiki/Component_placement

   Component placement is an electronics manufacturing process that places electrical components precisely on printed circuit boards (PCBs) to create electrical interconnections between functional components and the interconnecting circuitry in the PCBs (leads-pads). The component leads must be accurately immersed in the solder paste previously ...

7. Coupon (PWB) - Wikipedia

   en.wikipedia.org/wiki/Coupon_(PWB)

   A coupon or test coupon is a printed circuit board (PCB) used to test the quality of a printed wiring board (PWB) fabrication process. Test coupons are fabricated on the same panel as the PWBs, typically at the edges. Coupons are then inspected to ensure proper layer alignment, electrical connectivity, and cross sectioned to inspect internal ...

8. Thick-film technology - Wikipedia

   en.wikipedia.org/wiki/Thick-film_technology

   Thick film technology is also one of the alternatives to be used in hybrid integrated circuits and competes and complements typically in electronics miniaturization (parts or elements/area or volume) with SMT based on PCB (printed circuit board)/PWB (printed wiring board) and thin film technology. [4]

9. Rework (electronics) - Wikipedia

   en.wikipedia.org/wiki/Rework_(electronics)

   Reballing involves dismantling, heating the chip until it can be removed from the board, typically with a hot-air gun and vacuum pickup tool, removing the device, removing solder remaining on the device and board, putting new solder balls in place, replacing the original device if there was a poor connection, or using a new one, and heating the ...