Search results
Results from the WOW.Com Content Network
In data communications, flow control is the process of managing the rate of data transmission between two nodes to prevent a fast sender from overwhelming a slow receiver. Flow control should be distinguished from congestion control , which is used for controlling the flow of data when congestion has actually occurred. [ 1 ]
In most communication systems, the transmitting point applies source coding, [2] followed by channel coding, and lastly, line coding. This produces the baseband signal. The presence of filters may perform pulse shaping. Some systems then use modulation to multiplex many baseband signals into a broadband signal. The receiver un-does these ...
Many models of communication include the idea that a sender encodes a message and uses a channel to transmit it to a receiver. Noise may distort the message along the way. The receiver then decodes the message and gives some form of feedback. [1] Models of communication simplify or represent the process of communication.
The SMCR model is usually described as a linear transmission model of communication. [4] [17] Its main focus is to identify the basic parts of communication and to show how their characteristics shape the communicative process. In this regard, Berlo understands his model as "a model of the ingredients of communication". [24]
In the TS-ADC, this limitation is overcome by time-stretching the analog signal, which effectively slows down the signal in time prior to digitization. By doing so, the bandwidth (and carrier frequency) of the signal is compressed. Electronic ADCs that would have been too slow to digitize the original signal can now be used to capture and ...
The model allows transparent communication through equivalent exchange of protocol data units (PDUs) between two parties, through what is known as peer-to-peer networking (also known as peer-to-peer communication). As a result, the OSI reference model has not only become an important piece among professionals and non-professionals alike, but ...
The SIGSEGV signal is sent to a process when it makes an invalid virtual memory reference, or segmentation fault, i.e. when it performs a segmentation violation. [19] SIGSTOP The SIGSTOP signal instructs the operating system to stop a process for later resumption. SIGSYS The SIGSYS signal is sent to a process when it passes a bad argument to a ...
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires, optical fibers, wireless communication using radio spectrum, storage media and computer buses.