Search results
Results from the WOW.Com Content Network
Note the decrease in ΔG ‡ activation for the polar-solvent reaction conditions. This arises from the fact that polar solvents stabilize the formation of the carbocation intermediate to a greater extent than the non-polar-solvent conditions. This is apparent in the ΔE a, ΔΔG ‡ activation. On the right is an S N 2 reaction coordinate diagram.
The integral heat of dissolution is defined as a process of obtaining a certain amount of solution with a final concentration. The enthalpy change in this process, normalized by the mole number of solute, is evaluated as the molar integral heat of dissolution. Mathematically, the molar integral heat of dissolution is denoted as:
Polar solvents can be used to dissolve inorganic or ionic compounds such as salts. The conductivity of a solution depends on the solvation of its ions. Nonpolar solvents cannot solvate ions, and ions will be found as ion pairs. Hydrogen bonding among solvent and solute molecules depends on the ability of each to accept H-bonds, donate H-bonds ...
Calcium chloride was apparently discovered in the 15th century but wasn't studied properly until the 18th century. [11] It was historically called "fixed sal ammoniac" (Latin: sal ammoniacum fixum [12]) because it was synthesized during the distillation of ammonium chloride with lime and was nonvolatile (while the former appeared to sublime); in more modern times (18th-19th cc.) it was called ...
Solvent exchange is generally slower for trivalent than for divalent ions, as the higher electrical charge on the cation makes for stronger M-OH 2 bonds and, in consequence, higher activation energy for the dissociative reaction step, [M(H 2 O) n] 3+ → [M(H 2 O) n-1] 3+ + H 2 O. The values in the table show that this is due to both activation ...
In a dissolution process, a solute is changed from a pure phase—solid, liquid, or gas—to a solution phase. If the pure phase of the solute is a solid or gas (presuming the solvent itself is liquid), the process can be seen in two stages: the phase change into a liquid, and the mixing of liquids. The dissolution process is generally ...
The solvent utilized in single-solvent recrystallization must dissolve the crude reaction mixture only when it is heated to reflux. [3] The heated solution is then passively cooled, yielding a crystallized product absent of impurities. [3] The solid crystals are then collected utilizing a filtration apparatus and the filtrate is discarded. [4]
The hydrophobic effect is the observed tendency of nonpolar substances to aggregate in an aqueous solution and to be excluded by water. [ 1 ] [ 2 ] The word hydrophobic literally means "water-fearing", and it describes the segregation of water and nonpolar substances, which maximizes the entropy of water and minimizes the area of contact ...