Search results
Results from the WOW.Com Content Network
LED power dissipation is modeled as a current source; thermal resistance is modeled as a resistor; and the ambient temperature is modeled as a voltage source. High power light-emitting diodes (LEDs) can use 350 milliwatts or more in a single LED. Most of the electricity in an LED becomes heat rather than light – about 70% heat and 30% light. [1]
The light from white LED lamps and LED strip lights is usually provided by industry standard surface-mounted device LEDs (SMD LEDs). [2] Non-SMD types of LED lighting also exist, such as COB (chip on board) and MCOB (multi-COB). Surface-mounted device LED modules are described by the dimensions of the LED package. A single multicolor module may ...
Flat no-leads, also known as micro leadframe (MLF) and SON (small-outline no leads), is a surface-mount technology, one of several package technologies that connect ICs to the surfaces of PCBs without through-holes. Flat no-lead is a near chip scale plastic encapsulated package made with a planar copper lead frame substrate.
Many circuits operate LEDs at less than the specified maximum current to save power, or to reduce brightness, or to use a common resistor value. For indoor use, tiny surface mount high-efficiency LEDs can easily light up with 1 mA (0.001 A) or more current, which most digital logic outputs can easily source or sink.
Reflow soldering with long industrial convection ovens is the preferred method of soldering surface mount technology (SMT) components to a printed circuit board (PCB). Each segment of the oven has a regulated temperature, according to the specific thermal requirements of each assembly.
Solder paste is used in the manufacture of printed circuit boards to connect surface mount components to pads on the board. It is also possible to solder through-hole pin in paste components by printing solder paste in and over the holes. The sticky paste temporarily holds components in place; the board is then heated, melting the paste and ...
Sensors installed to a fixture to check selective solder machine parameters Selective soldering machine. Selective soldering is the process of selectively soldering components to printed circuit boards and molded modules that could be damaged by the heat of a reflow oven or wave soldering in a traditional surface-mount technology (SMT) or through-hole technology assembly processes.
Surface-mount technology (SMT), originally called planar mounting, [1] is a method in which the electrical components are mounted directly onto the surface of a printed circuit board (PCB). [2] An electrical component mounted in this manner is referred to as a surface-mount device ( SMD ).