Search results
Results from the WOW.Com Content Network
The original TCP configurations supported TCP receive window size buffers of up to 65,535 (64 KiB - 1) bytes, which was adequate for slow links or links with small RTTs. Larger buffers are required by the high performance options described below. Buffering is used throughout high performance network systems to handle delays in the system.
In computer networking, the maximum transmission unit (MTU) is the size of the largest protocol data unit (PDU) that can be communicated in a single network layer transaction. [1]: 25 The MTU relates to, but is not identical to the maximum frame size that can be transported on the data link layer, e.g., Ethernet frame.
iperf, Iperf, or iPerf, is a tool for network performance measurement and tuning. It is a cross-platform tool that can produce standardized performance measurements for any network. iperf has client and server functionality, and can create data streams to measure the throughput between the two ends in one or both directions. [2]
Bandwidth test software is used to determine the maximum bandwidth of a network or internet connection. It is typically undertaken by attempting to download or upload the maximum amount of data in a certain period of time, or a certain amount of data in the minimum amount of time.
If the data in a single write spans 2n packets, where there are 2n-1 full-sized TCP segments followed by a partial TCP segment, the original Nagle algorithm would withhold the last packet, waiting for either more data to send (to fill the packet), or the ACK for the previous packet (indicating that all the previous packets have left the network).
The speed of light imposes a minimum propagation time on all electromagnetic signals. It is not possible to reduce the latency below = / where s is the distance and c m is the speed of light in the medium (roughly 200,000 km/s for most fiber or electrical media, depending on their velocity factor).
1. Check to see if the destination is an address ‘owned’ by this computer. If so, process the packet. If not: a. Check to see if IP Forwarding is set to ‘Yes’. If no, the packet is destroyed. If yes, then i. Check to see if a network attached to this computer owns the destination address. If yes, route the packet to the appropriate network.
Frame bursting may increase the throughput of any (point-to-point) 802.11a, b, g or n link connection under certain conditions. This is done by reducing the overhead associated with the wireless session in either of the following two modes: Access point to client and vice versa