enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

3. LED filament - Wikipedia

   en.wikipedia.org/wiki/LED_filament

   A 230-volt LED filament light bulb, with a B22 base. The filaments are visible as the four yellow vertical lines. A LED filament light bulb is a LED lamp which is designed to resemble a traditional incandescent light bulb with visible filaments for aesthetic and light distribution purposes, but with the high efficiency of light-emitting diodes (LEDs).

4. Light-emitting diode - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode

   As of 2011, some LED bulbs provide up to 150 lm/W and even inexpensive low-end models typically exceed 50 lm/W, so that a 6-watt LED could achieve the same results as a standard 40-watt incandescent bulb. The lower heat output of LEDs also reduces demand on air conditioning systems.

5. Luminous efficacy - Wikipedia

   en.wikipedia.org/wiki/Luminous_efficacy

   It is the ratio of luminous flux to power, measured in lumens per watt in the International System of Units (SI). Depending on context, the power can be either the radiant flux of the source's output, or it can be the total power (electric power, chemical energy, or others) consumed by the source.

6. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   In CC drivers, the voltage changes while the current stays the same. CC drivers are used when the electrical load of the LED circuit is either unknown or fluctuates, for example, a lighting circuit where a variable number of LED lamp fixtures may be installed. As an LED heats up, its voltage drop decreases (band gap decrease [1]). This can ...

7. Multifaceted reflector - Wikipedia

   en.wikipedia.org/wiki/Multifaceted_reflector

   These lamps use a bi-pin connector for power: 12-volt MR11 bulbs usually use a GU4 base, and 12-volt MR16 bulbs usually use a GU5.3 base. The common 12-volt MR16 lamps, therefore, require a ferromagnetic or electronic transformer —sometimes misnamed as a ballast —to convert the 120- or 230-volt mains voltage to the extra-low voltage ...