Search results
Results from the WOW.Com Content Network
The gas-lift mandrel is a device installed in the tubing string of a gas-lift well onto which or into which a gas-lift valve is fitted. There are two common types of mandrels. In a conventional gas-lift mandrel, a gas-lift valve is installed as the tubing is placed in the well. Thus, to replace or repair the valve, the tubing string must be pulled.
An airlift pump, powered by compressed air, raises fluid by entraining gas to reduce its density. 1. air supply 2. liquid supply 3. air inlet port
Petroleum production engineers design and select subsurface equipment to produce oil and gas well fluids. [1] They often are degreed as petroleum engineers, although they may come from other technical disciplines (e.g., mechanical engineering, chemical engineering, physicist) and subsequently be trained by an oil and gas company.
They show an almost linear increase in lift coefficient with increasing angle of attack with a gradient known as the lift slope. For a thin airfoil of any shape the lift slope is π 2 /90 ≃ 0.11 per degree. At higher angles a maximum point is reached, after which the lift coefficient reduces.
A production packer [1] is a standard component of the completion hardware of oil or gas wells used to provide a seal between the outside of the production tubing and the inside of the casing, liner, or wellbore wall. Based on their primary use, packers can be divided into two main categories: production packers and service packers.
Artificial lift is the use of artificial means to increase the flow of liquids, such as crude oil or water, from a production well. Generally this is achieved by the use of a mechanical device inside the well (known as pump or velocity string) or by decreasing the weight of the hydrostatic column by injecting gas into the liquid some distance down the well.
Careful design is required to pump high temperature liquids with a centrifugal pump when the liquid is near its boiling point. The violent collapse of the cavitation bubble creates a shock wave that can carve material from internal pump components (usually the leading edge of the impeller) and creates noise often described as "pumping gravel".
However, while it does generate lift, it also generates a large amount of drag. [8] Since even a flat plate can generate lift, a significant factor in foil design is the minimization of drag. An example of this is the rudder of a boat or aircraft. When designing a rudder a key design factor is the minimization of drag in its neutral position ...