enow.com Web Search

  1. Ads

    related to: pex expansion tool auto rotate machine extension

Search results

  1. Results from the WOW.Com Content Network
  2. Turboexpander - Wikipedia

    en.wikipedia.org/wiki/Turboexpander

    A turboexpander, also referred to as a turbo-expander or an expansion turbine, is a centrifugal or axial-flow turbine, through which a high-pressure gas is expanded to produce work that is often used to drive a compressor or generator.

  3. Cross-linked polyethylene - Wikipedia

    en.wikipedia.org/wiki/Cross-linked_polyethylene

    A cross-linked polyethylene (PEX) pipe. Cross-linked polyethylene, commonly abbreviated PEX, XPE or XLPE, is a form of polyethylene with cross-links.It is used predominantly in building services pipework systems, hydronic radiant heating and cooling systems, domestic water piping, insulation for high tension (high voltage) electrical cables, and baby play mats.

  4. Push-to-pull compression fittings - Wikipedia

    en.wikipedia.org/wiki/Push-to-pull_compression...

    A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).

  5. List of abbreviations in oil and gas exploration and production

    en.wikipedia.org/wiki/List_of_abbreviations_in...

    UCIT – ultrasonic casing imaging tool (high resolution casing and corrosion imaging tool [citation needed]) UCL – unit control logic; UCR – unsafe condition report; UCS – unconfined compressive strength; UCSU – upstream commissioning and start-up; UFJ – upper flex joint; UFR – umbilical flow lines and risers; UGF – universal ...

  6. G-code - Wikipedia

    en.wikipedia.org/wiki/G-code

    Extensions and variations have been added independently by control manufacturers and machine tool manufacturers, and operators of a specific controller must be aware of the differences between each manufacturer's product. One standardized version of G-code, known as BCL (Binary Cutter Language), is used only on very few machines. Developed at ...

  7. Automatic tool changer - Wikipedia

    en.wikipedia.org/wiki/Automatic_Tool_Changer

    The ATC arm comes to this position and picks up the tool. The arm swivels between the machine turret and the magazine. It will have one gripper on each of the two sides. Each gripper can rotate 90°, to deliver tools to the front face of the turret. One will pick up the old tool from the turret and the other will pick up the new tool from the ...

  1. Ads

    related to: pex expansion tool auto rotate machine extension