enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Screw terminal - Wikipedia

   en.wikipedia.org/wiki/Screw_terminal

   When properly tightened, the connections are physically and electrically secure because they firmly contact a large section of wire. The terminals are relatively low cost compared with other types of connector, and a screw terminal can easily be integrated into the design of a building wiring device (such as a socket, switch, or lamp holder).

3. Point-to-point construction - Wikipedia

   en.wikipedia.org/wiki/Point-to-point_construction

   A terminal strip has stamped tin-plated copper terminals, each with a hole through which wire ends could be pushed, fitted on an insulating strip, usually made of a cheap, heat-resistant material such as synthetic-resin bonded paper , or bakelite reinforced with cotton. The insulator has an integral mounting bracket, sometimes electrically ...

4. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Chassis or panel connectors permanently attached to a piece of equipment so users can connect a cable to a stationary device; PCB mount connectors soldered to a printed circuit board, providing a point for cable or wire attachment. [6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors)

5. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated:

6. Board-to-board connector - Wikipedia

   en.wikipedia.org/wiki/Board-to-board_connector

   Board-to-board (BTB) connectors are used to connect printed circuit boards (PCB), electronic components that contain a conductive pattern printed on the surface of the insulating base in an accurate and repeatable manner. Each terminal on a BTB connector is connected to a PCB. A BTB connector includes housing and a specific number of terminals.

7. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   A minimal PCB for a single component, used for prototyping, is called a breakout board. The purpose of a breakout board is to "break out" the leads of a component on separate terminals so that manual connections to them can be made easily. Breakout boards are especially used for surface-mount components or any components with fine lead pitch.