Search results
Results from the WOW.Com Content Network
Subtension refers to the length between two points on a target, and is usually given in either centimeters, millimeters or inches. Since an mrad is an angular measurement, the subtension covered by a given angle (angular distance or angular diameter) increases with viewing distance to the target. For instance the same angle of 0.1 mrad will ...
A 1951 USAF resolution test chart is a microscopic optical resolution test device originally defined by the U.S. Air Force MIL-STD-150A standard of 1951. The design provides numerous small target shapes exhibiting a stepped assortment of precise spatial frequency specimens.
Some Leupold hunting sights with duplex reticles allow range estimation to a White-tailed deer buck by adjusting magnification until the area between the backbone and the brisket fits between the crosshairs and the top thick post of the reticle. Once that is done, the range be read from the scale printed on the magnification adjustment ring.
The LED as a reticle is an innovation that greatly improves the reliability and general usefulness of the sight. There is no need for other optical elements to focus light behind a reticle. The LED itself is solid state and consumes very little power, allowing battery powered sights to run for hundreds and even tens of thousands of hours. Using ...
Leupold & Stevens, Inc. is an American manufacturer of telescopic sights, red dot sights, binoculars, rangefinders, spotting scopes, and eyewear located in Beaverton, Oregon, United States. The company, started in 1907, is on its fifth generation of family ownership.
By using a reticle with marks of a known angular spacing, the principle of similar triangles can be used to find either the distance to objects of known size or the size of objects at a known distance. In either case, the known parameter is used, in conjunction with the angular measurement, to derive the length of the other side.
Using an LED as a reticle is an innovation that greatly improves the reliability and general usefulness of the sight: there is no need for other optical elements to focus light behind a reticle; the mirror can use a dichroic coating to reflect just the red spectrum, passing through most other light; and the LED itself is solid state and ...
Reticle burn-in was also addressed. One issue that persists even in production models is the tendency for the projected reticle pattern to become washed out in bright light. This can be somewhat mitigated by adjusting the Reticle Brightness knob to its brightest position and keeping the Tube Brightness knob as low as possible.