Search results
Results from the WOW.Com Content Network
The run-time for a battery-operated UPS depends on the type and size of batteries and rate of discharge, and the efficiency of the inverter. The total capacity of a lead–acid battery is a function of the rate at which it is discharged, which is described as Peukert's law. Manufacturers supply run-time rating in minutes for packaged UPS systems.
Network UPS Tools (NUT) is a suite of software component designed to monitor power devices, such as uninterruptible power supplies, power distribution units, solar controllers and servers power supply units. Many brands and models are supported and exposed via a network protocol and standardized interface.
Installation (or setup) of a computer program (including device drivers and plugins), is the act of making the program ready for execution. Installation refers to the particular configuration of software or hardware with a view to making it usable with the computer. A soft or digital copy of the piece of software (program) is needed to install it.
[citation needed] It is rare to find rechargeable batteries in such systems. Backup batteries are used in uninterruptible power supplies (UPS), and provide power to the computers they supply for a variable period after a power failure, usually long enough to at least allow the computer to be shut down gracefully. [4]
To be used efficiently, all computer software needs certain hardware components or other software resources to be present on a computer. [1] These prerequisites are known as (computer) system requirements and are often used as a guideline as opposed to an absolute rule. Most software defines two sets of system requirements: minimum and recommended.
APC Smart-UPS is a line of smaller units intended for home and office use, available as floor-standing and rackmount versions. With the exception of the Smart-UPS Online series (SURT and SRT models), Smart-UPS units are line-interactive UPS systems, running their outputs off the inverters only when the grid power is unavailable.
The Manchester Baby, by the Victoria University of Manchester, was the first fully electronic computer to run a stored program. It ran a factoring program for 52 minutes on June 21, 1948, after running a simple division program and a program to show that two numbers were relatively prime.
Loading a program involves either memory-mapping or copying the contents of the executable file containing the program instructions into memory, and then carrying out other required preparatory tasks to prepare the executable for running. Once loading is complete, the operating system starts the program by passing control to the loaded program ...