enow.com Web Search

  1. Ads

    related to: cost of replacing a sewage ejector pump

Search results

  1. Results from the WOW.Com Content Network
  2. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    In situations where a downward slope out of a building en route to a treatment system cannot be created, a special collection sump pit and grinding lift "sewage ejector" pump are needed. By contrast, potable water supply systems are pressurized up to 50 pounds per square inch (340 kPa) or more and so do not require a continuous downward slope ...

  3. Sewage pumping - Wikipedia

    en.wikipedia.org/wiki/Sewage_pumping

    KOS+ M openwell submersible pump. Small-scale sewage pumping is normally done by a submersible pump.. This became popular in the early 1960s, when a guide rail system was developed to lift the submersible pump out of the pump station for repair, and ended the dirty and sometimes dangerous task of sending people into the sewage or wet pit. [1]

  4. Sewerage - Wikipedia

    en.wikipedia.org/wiki/Sewerage

    Sewerage (or sewage system) is the infrastructure that conveys sewage or surface runoff (stormwater, meltwater, rainwater) using sewers. It encompasses components such as receiving drains , manholes , pumping stations , storm overflows, and screening chambers of the combined sewer or sanitary sewer .

  5. Pumping station - Wikipedia

    en.wikipedia.org/wiki/Pumping_station

    A four pole or six pole AC induction motor normally drives the pump. Rather than provide large open passages, some pumps, typically smaller sewage pumps, also macerate any solids within the sewage breaking them down into smaller parts which can more easily pass through the impeller. The interior of a sewage pump station is a very dangerous place.

  6. Grinder pump - Wikipedia

    en.wikipedia.org/wiki/Grinder_pump

    A pump for household use is usually 1 hp, 1.5 hp or 2 hp. A cutting mechanism macerates waste and grinds items that are not normally found in sewage, but may get flushed down the toilet. The pump has a level sensor either built into the pump, called “sensing bells,” or attached externally to the pump, typically a float switch. (The level ...

  7. Facing $100 million in costs to replace lead pipes, Newport ...

    www.aol.com/facing-100-million-costs-replace...

    In total, including administrative costs and costs to replace the water mains, Schultz estimated that the city could be facing anywhere from $100 million to $105 million.

  1. Ads

    related to: cost of replacing a sewage ejector pump