Ads
related to: pouring concrete over existing surfaces drain hole in housetrustedhippo.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
In civil engineering, concrete leveling is a procedure that attempts to correct an uneven concrete surface by altering the foundation that the surface sits upon. It is a cheaper alternative to having replacement concrete poured and is commonly performed at small businesses and private homes as well as at factories, warehouses, airports and on roads, highways and other infrastructure.
In poured concrete foundations, cracks and pipe penetrations are the most common entry points for seepage. These openings can be sealed from the interior. Epoxies , which are strong adhesives, or urethanes can be pressure injected into the openings, thus penetrating the foundation through to the exterior and cutting off the path of the seepage.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
The floor is typically sloped towards a drain point, in case of leaks. Modern construction for basement walls typically falls into one of two categories: they will be made of poured-in-place concrete using concrete forms with a concrete pump, or they will use concrete masonry units (block walls). Rock may also be used, but is less common.
The tremie concrete placement method uses a vertical or nearly vertical pipe, through which concrete is placed by gravity feed below water level. [4]The lower end of the pipe is kept immersed in fresh concrete so that concrete rising from the bottom displaces the water above it, thus limiting washing out of the cement content of the fresh concrete at the exposed upper surface.
The concrete is poured in to form the base with slopes from the precast concrete wall down to the half point of the existing pipe. This forms a half bench for the manhole base. The top half of that existing pipe is cut open to form a channel. A new pipe is inserted through the wall hole.
Ads
related to: pouring concrete over existing surfaces drain hole in housetrustedhippo.com has been visited by 100K+ users in the past month