enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   The 24-pin double-sided connector provides four power–ground pairs, two differential pairs for USB 2.0 data (though only one pair is implemented in a USB-C cable), four pairs for SuperSpeed data bus (only two pairs are used in USB 3.1 mode), two "sideband use" pins, V CONN +5 V power for active cables, and a configuration pin for cable ...

3. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   An alternative to this is a compound device, in which the host assigns each logical device a distinct address and all logical devices connect to a built-in hub that connects to the physical USB cable. USB endpoints reside on the connected device: the channels to the host are referred to as pipes.

4. USB-C - Wikipedia

   en.wikipedia.org/wiki/USB-C

   Some non-compliant cables with a USB-C connector on one end and a legacy USB-A plug or Micro-B receptacle (receptacles also usually being invalid on cables, but see known exceptions in the sections on Hosts and peripheral devices and Audio adapter accessory mode above) on the other end incorrectly terminate the Configuration Channel (CC) with a ...

5. USB communications - Wikipedia

   en.wikipedia.org/wiki/USB_communications

   The half-duplex lines are still used for configuration. SuperSpeed+ (SS+) uses increased signaling rate (Gen 2×1 mode) and/or the additional lane in the Type-C connector (Gen 1×2 and Gen 2×2 mode). A USB connection is always between a host or hub at the A connector end, and a device or hub's upstream port at the other end.

6. USB On-The-Go - Wikipedia

   en.wikipedia.org/wiki/USB_On-The-Go

   USB On-The-Go (USB OTG or just OTG) is a specification first used in late 2001 that allows USB devices, such as tablets or smartphones, to also act as a host, allowing other USB devices, such as USB flash drives, digital cameras, mice or keyboards, to be attached to them. Use of USB OTG allows devices to switch back and forth between the roles ...

7. USB 3.0 - Wikipedia

   en.wikipedia.org/wiki/USB_3.0

   Under the USB 3.2 specification, released 22 September 2017, [11] existing SuperSpeed certified USB-C 3.1 Gen 1 cables will be able to operate at 10 Gbit/s (up from 5 Gbit/s), and SuperSpeed+ certified USB-C 3.1 Gen 2 cables will be able to operate at 20 Gbit/s (up from 10 Gbit/s). The increase in bandwidth is a result of multi-lane operation ...