Search results
Results from the WOW.Com Content Network
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...
Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two conductors) runs from the amplifier output to the terminals at the loudspeaker housing.
A wiring diagram for parts of an electric guitar, showing semi-pictorial representation of devices arranged in roughly the same locations they would have in the guitar. An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
These show and name the termination points and names of each conductor. In some systems, enough information can be put onto the schematics so that wiring diagrams are not needed. Physically smaller systems that are built many times may use a cable harness. A full-sized to-scale wiring diagram can be made of a cable harness.
Alternatively, one rear speaker can be used on its own. This is the type of quad setup used by Seeburg jukeboxes that had quadraphonic sound. [ citation needed ] The Hafler circuit is capable of partially decoding a Dolby Surround track since both share the same operating principles (based on sound phase differences).
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.