enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. French drain - Wikipedia

   en.wikipedia.org/wiki/French_drain

   A diagram of a traditional French drain. A French drain [1] (also known by other names including trench drain, blind drain, [1] rubble drain, [1] and rock drain [1]) is a trench filled with gravel or rock, or both, with or without a perforated pipe that redirects surface water and groundwater away from an area.

3. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

4. Trench drain - Wikipedia

   en.wikipedia.org/wiki/Trench_drain

   Channels can range from 1 inch (2.5 cm) to 2 feet (61 cm) in width, while depths can reach up to 4 feet (120 cm). Trench drains are commonly confused with French drains , which consist of a perforated pipe that is buried in a gravel bed, and which are used to evacuate ground water.

5. Basement waterproofing - Wikipedia

   en.wikipedia.org/wiki/Basement_waterproofing

   A French drain, PVC pipe, or other drainage system is installed in the newly made channel. The installed drain is covered with new cement. The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of

6. Plumbing drawing - Wikipedia

   en.wikipedia.org/wiki/Plumbing_drawing

   In shop drawings pipe sizes should be marked with the text and size should be shown with double line. Each pipes with different purposes will be displayed with different colors for ease of understanding. Drainage pipes should be shown with slope. For water supply, pump capacity and number of pumps will be attached as drawing file.

7. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   Pipe sizes can be confusing because the terminology may relate to historical dimensions. For example, a half-inch iron pipe does not have any dimension that is a half inch. Initially, a half inch pipe did have an inner diameter of 1 ⁄ 2 inch (13 mm)—but it also had thick walls. As technology improved, thinner walls became possible, but the ...