enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bar stock - Wikipedia

   en.wikipedia.org/wiki/Bar_stock

   There are four types of materials available: O-1 tool steel, A-2 tool steel, A-6 tool steel, and 1018 steel (low-carbon or low-carb steel). Lengths are either 18 or 36 in (457 or 914 mm) long, various widths up to 16 in (406 mm) are available, and thicknesses range from 1 ⁄ 64 to 2.875 in (0.40 to 73.03 mm).

3. Structural steel - Wikipedia

   en.wikipedia.org/wiki/Structural_steel

   Structural steel. Structural steel is a category of steel used for making construction materials in a variety of shapes. Many structural steel shapes take the form of an elongated beam having a profile of a specific cross section. Structural steel shapes, sizes, chemical composition, mechanical properties such as strengths, storage practices ...

4. Semi-finished casting products - Wikipedia

   en.wikipedia.org/wiki/Semi-finished_casting_products

   A billet is a length of metal that has a round or square cross-section, with an area less than 36 in 2 (230 cm 2). Billets are created directly via continuous casting or extrusion or indirectly via hot rolling an ingot or bloom. [1][2][4] Billets are further processed via profile rolling and drawing. Final products include bar stock and wire. [3]

5. Rebar - Wikipedia

   en.wikipedia.org/wiki/Rebar

   US/Imperial bar sizes give the diameter in units of 1 ⁄ 8 inch (3.2 mm) for bar sizes #2 through #8, so that #8 = 8 ⁄ 8 inch = 1-inch (25 mm) diameter. There are no fractional bar sizes in this system. The "#" symbol indicates the number sign, and thus "#6" is read as "number six". The use of the "#" sign is customary for US sizes, but "No ...

6. Continuous casting - Wikipedia

   en.wikipedia.org/wiki/Continuous_casting

   Continuous casting, also called strand casting, is the process whereby molten metal is solidified into a "semifinished" billet, bloom, or slab for subsequent rolling in the finishing mills. Prior to the introduction of continuous casting in the 1950s, steel was poured into stationary molds to form ingots. Since then, "continuous casting" has ...

7. Sheet metal - Wikipedia

   en.wikipedia.org/wiki/Sheet_metal

   Sheet metal is metal formed into thin, flat pieces, usually by an industrial process. Thicknesses can vary significantly; extremely thin sheets are considered foil or leaf, and pieces thicker than 6 mm (0.25 in) are considered plate, such as plate steel, a class of structural steel. Sheet metal is available in flat pieces or coiled strips.