enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   Pass-through sockets and ratchets are built for 1 ⁄ 4-inch, 3 ⁄ 8-inch and 1 ⁄ 2-inch sets in both SAE and metric sizes. By using a fine tooth ratchet and socket system that allow a pass-through ratchet to be used as a conventional ratchet handle with interchangeable 1 ⁄ 4-inch and 3 ⁄ 8-inch drives some ratchets can be used with ...

3. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   The hex drive is better than square drive for locations where surrounding obstacles limit wrenching access, because smaller wrench-swing arcs can still successfully rotate the fastener. Metric sizes of the hex are specified by ISO 4032 and ISO 4033, plus ISO 4035 for Jam Nuts, and ISO 4014 and ISO 4017 for hex cap screws, ISO 4018 for Hex head ...

4. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

5. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

6. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   The idea of a hex socket screw drive was probably conceived as early as the 1860s to the 1890s, but such screws were probably not manufactured until around 1910. Rybczynski (2000) describes a flurry of patents for alternative drive types in the 1860s to the 1890s in the U.S., [2] which are confirmed to include internal-wrenching square and triangle types (that is, square and triangular sockets ...

7. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   Machine screws with different thread diameters Hex key set with metric sizes from 2 mm to 10 mm according to sizes for use with ISO 262 screw sizes (except 3.5 mm for M6 internal set screw) For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including: