Ad
related to: water and dust resistance testing
Search results
Results from the WOW.Com Content Network
IP65 touchscreen display IP65 LED lamp. The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [1] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical enclosures against ...
MIL-STD-810 is maintained by a Tri-Service partnership that includes the United States Air Force, Army, and Navy. [2] The U.S. Army Test and Evaluation Command, or ATEC, serves as Lead Standardization Activity / Preparing Activity, and is chartered under the Defense Standardization Program (DSP) with maintaining the functional expertise and serving as the DoD-wide technical focal point for the ...
IEC 60068 is an international standard for the environmental testing of electrotechnical products that is published by the International Electrotechnical Commission (IEC).. IEC 60068 is a collection of methods [1] for environmental testing of electronic equipment and products to assess their ability to perform under environmental conditions including extreme cold and dry heat.
Meets drip and corrosion-resistance tests. 12 and 12K: General-purpose. Intended for indoor use, provides some protection against dust, falling dirt, and dripping non-corrosive liquids. Meets drip, dust, and rust resistance tests. 13: General-purpose. Primarily used to provide protection against dust, spraying of water and non-corrosive coolants.
Water proofness: These tests subject the test article to various scenarios of dripping water or pooled water to verify the unit will fully operate in the given condition. 11.0 Fluids susceptibility: Aviation related fluids susceptibility including a variety of fluids ranging from carbonated sugared beverage to various cleaners and solvents. 12. ...
The salt spray test (or salt fog test) is a standardized and popular corrosion test method, used to check corrosion resistance of materials and surface coatings.Usually, the materials to be tested are metallic (although stone, ceramics, and polymers may also be tested) and finished with a surface coating which is intended to provide a degree of corrosion protection to the underlying metal.
Vandal-resistant switches often need to be water and dust resistant due to their environments. Some types are potted to make them waterproof. The International Electrotechnical Commission has produced a standard, IEC 60529, which categorizes products' degrees of protection from liquids and dust using IP codes.
The complete test requires 500 drum revolutions at a speed of 30-33 revolutions per minute. [6] Crushed sample is then separated from fine dust on a sieve, washed, dried and weighed. [6] The test reports loss of mass to abrasion and impact, expressed as a percentage of initial sample mass. [7]
Ad
related to: water and dust resistance testing