Search results
Results from the WOW.Com Content Network
The index is the ratio of "BogoMips per clock speed" for any CPU to the same for an Intel 386DX CPU, for comparison purposes. ... With the 2.2.14 Linux kernel, a ...
The Time Stamp Counter was once a high-resolution, low-overhead way for a program to get CPU timing information. With the advent of multi-core/hyper-threaded CPUs, systems with multiple CPUs, and hibernating operating systems, the TSC cannot be relied upon to provide accurate results — unless great care is taken to correct the possible flaws: rate of tick and whether all cores (processors ...
Clock rate or clock speed in computing typically refers to the frequency at which the clock generator of a processor can generate pulses used to synchronize the operations of its components. [1] It is used as an indicator of the processor's speed. Clock rate is measured in the SI unit of frequency hertz (Hz).
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
The dynamic power (switching power) dissipated by a chip is C·V 2 ·A·f, where C is the capacitance being switched per clock cycle, V is voltage, A is the activity factor [1] indicating the average number of switching events per clock cycle by the transistors in the chip (as a unitless quantity) and f is the clock frequency.
The Linux kernel has a subsystem called "cpufreq", tunable by power-scheme and command line, devoted to the control of the operating frequency and voltage of a CPU. Linux runs on Intel, AMD, and other makes of CPU. [13] [14] Newer version Windows 10 and Linux kernel support Intel Speed Shift Technology.
In early processors, the TSC was a cycle counter, incrementing by 1 for each clock cycle (which could cause its rate to vary on processors that could change clock speed at runtime) – in later processors, it increments at a fixed rate that doesn't necessarily match the CPU clock speed. [n] Usually 3 [o] Intel Pentium, AMD K5, Cyrix 6x86MX ...
The Linux kernel can also use HPET as its clock source. The documentation of Red Hat MRG version 2 states that TSC is the preferred clock source due to its much lower overhead, but it uses HPET as a fallback. A benchmark in that environment for 10 million event counts found that TSC took about 0.6 seconds, HPET took slightly over 12 seconds ...