Search results
Results from the WOW.Com Content Network
Dual, Quad and Octal 5 V PCI bus UARTs with 16C550 Compatible Registers, 64-byte Transmit and Receive FIFOs, Transmit and Receive FIFO Level Counters, Automatic RTS/CTS or DTR/DSR Flow Control, Automatic Xon/Xoff Software Flow Control, RS485 Half-duplex Control with Selectable Delay, Infrared (IrDA 1.0) Data Encoder/Decoder, Programmable Data ...
The word "uno" means "one" in Italian and was chosen to mark a major redesign of the Arduino hardware and software. [7] The Uno board was the successor of the Duemilanove release and was the 9th version in a series of USB-based Arduino boards. [8] Version 1.0 of the Arduino IDE for the Arduino Uno board has now evolved to newer releases. [4]
In the real world some low-end devices may only support a subset of these 488.2 commands, or may even accept the commands but not perform any operation. A user should check the official programmers manual for each device before assuming all of these 488.2 commands are supported.
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.
The AVRISP and AVRISP mkII are inexpensive tools allowing all AVRs to be programmed via ICSP. The AVRISP connects to a PC via a serial port and draws power from the target system. The AVRISP allows using either of the "standard" ICSP pinouts, either the 10-pin or 6-pin connector. The AVRISP mkII connects to a PC via USB and draws power from USB.
The Arduino Nano is an open-source breadboard-friendly microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2008. It offers the same connectivity and specs of the Arduino Uno board in a smaller form factor.
Typically a command byte is sent requesting a response in dual mode, after which the MOSI line becomes SIO0 (serial I/O 0) and carries even bits, while the MISO line becomes SIO1 and carries odd bits. Data is still transmitted most-significant bit first, but SIO1 carries bits 7, 5, 3 and 1 of each byte, while SIO0 carries bits 6, 4, 2 and 0.