Search results
Results from the WOW.Com Content Network
Three types of plate boundary Convergent boundary Divergent boundary Transform boundary. Tectonic plate interactions are classified into three basic types: [1] Convergent boundaries are areas where plates move toward each other and collide. These are also known as compressional or destructive boundaries.
Where the plates meet, their relative motion determines the type of plate boundary (or fault): convergent, divergent, or transform. The relative movement of the plates typically ranges from zero to 10 cm annually. [5] Faults tend to be geologically active, experiencing earthquakes, volcanic activity, mountain-building, and oceanic trench formation.
Where the plates meet, their relative motion determines the type of plate boundary (or fault): convergent, divergent, or transform. The relative movement of the plates typically ranges from zero to 10 cm annually. Faults tend to be geologically active, experiencing earthquakes, volcanic activity, mountain-building, and oceanic trench formation.
A transform fault or transform boundary, is a fault along a plate boundary where the motion is predominantly horizontal. [1] It ends abruptly where it connects to another plate boundary, either another transform, a spreading ridge, or a subduction zone. [2] A transform fault is a special case of a strike-slip fault that also forms a plate boundary.
Continental-continental divergent/constructive boundary Oceanic divergent boundary: mid-ocean ridge (cross-section/cut-away view). In plate tectonics, a divergent boundary or divergent plate boundary (also known as a constructive boundary or an extensional boundary) is a linear feature that exists between two tectonic plates that are moving away from each other.
Mid-ocean ridges are divergent plate boundaries. As the plates on either side of an offset mid-ocean ridge move, a transform fault forms at the offset between the two ridges. [2] Fracture zones and the transform faults that form them are separate but related features. Transform faults are plate boundaries, meaning that on either side of the ...
Extensional tectonics is associated with the stretching and thinning of the crust or the lithosphere.This type of tectonics is found at divergent plate boundaries, in continental rifts, during and after a period of continental collision caused by the lateral spreading of the thickened crust formed, at releasing bends in strike-slip faults, in back-arc basins, and on the continental end of ...
There are three main types of faults: [1] normal faults, reverse faults and strike slip (transform) faults. All of these are ways the crust can deform is due to the different types of plate margins, which are: [2] divergent boundaries, convergent boundaries, and transform boundaries.