Ad
related to: physical structure of diode in electronics system
Search results
Results from the WOW.Com Content Network
Various semiconductor diodes. Left: A four-diode bridge rectifier.Next to it is a 1N4148 signal diode.On the far right is a Zener diode.In most diodes, a white or black painted band identifies the cathode into which electrons will flow when the diode is conducting.
Light-emitting diodes (LEDs) produce light (or infrared radiation) by the recombination of electrons and electron holes in a semiconductor, a process called "electroluminescence". The wavelength of the light produced depends on the energy band gap of the semiconductors used.
In an organic light-emitting diode , the electroluminescent material composing the emissive layer of the diode is an organic compound. The organic material is electrically conductive due to the delocalization of pi electrons caused by conjugation over all or part of the molecule, and the material therefore functions as an organic semiconductor ...
The two types of diode are in fact constructed in similar ways and both effects are present in diodes of this type. In silicon diodes up to about 5.6 volts, the Zener effect is the predominant effect and shows a marked negative temperature coefficient. Above 5.6 volts, the avalanche effect dominates and exhibits a positive temperature coefficient.
Therefore, geometric diodes can achieve frequency response into the THz. [5] The ability for a geometric diode's electronic properties to be tuned by the geometry of the structure, the surface coating on the structure, and the properties of the material used offer a level customization that is unrealized in any other diode system.
A p–n diode is a type of semiconductor diode based upon the p–n junction. The diode conducts current in only one direction, and it is made by joining a p-type semiconducting layer to an n-type semiconducting layer. Semiconductor diodes have multiple uses including rectification of alternating current to direct current, in the detection of ...
The PIN diode obeys the standard diode equation for low-frequency signals. At higher frequencies, the diode looks like an almost perfect (very linear, even for large signals) resistor. The P-I-N diode has a relatively large stored charge adrift in a thick intrinsic region. At a low-enough frequency, the stored charge can be fully swept and the ...
The DIAC (diode for alternating current) is a diode that conducts electrical current only after its breakover voltage, V BO, has been reached momentarily. Three, four, and five layer structures may be used. [1] Behavior is similar to the voltage breakdown of a triac without a gate terminal.
Ad
related to: physical structure of diode in electronics system