enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Help:Convert - Wikipedia

   en.wikipedia.org/wiki/Help:Convert

   A fraction is applied to the output unit (if there is only one), or to non-SI units (if using a combination), except that if a precision is also specified, the fraction only applies to the hand unit. {{convert|18.45|in|m|frac=2}} → 18.45 inches ( 1 ⁄ 2 m)

3. Sheet metal - Wikipedia

   en.wikipedia.org/wiki/Sheet_metal

   The progression of thicknesses is clear in column 3 (U.S. standard for sheet and plate iron and steel 64ths inch (delta)). The thicknesses vary first by 1 ⁄ 32 inch in higher thicknesses and then step down to increments of 1 ⁄ 64 inch, then 1 ⁄ 128 inch, with the final increments at decimal fractions of 1 ⁄ 64 inch.

4. Plywood - Wikipedia

   en.wikipedia.org/wiki/Plywood

   The most commonly used thickness range is from 1 ⁄ 8 to 3 inches (3.2–76.2 mm). The sizes of the most commonly used plywood sheets are 4 by 8 feet (1,220 mm × 2,440 mm) [20] which was first used by the Portland Manufacturing Company, who developed modern veneer core plywood for the 1905 Portland World Fair. A common metric size for a sheet ...

5. ANSI/ASME Y14.1 - Wikipedia

   en.wikipedia.org/wiki/ANSI/ASME_Y14.1

   A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A".

6. Inch - Wikipedia

   en.wikipedia.org/wiki/Inch

   Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as ⁠2 + 3 / 8 ⁠ ″ and not as 2.375″ nor as ⁠2 + 6 / 16 ⁠ ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...

7. Template:Convert - Wikipedia

   en.wikipedia.org/wiki/Template:Convert

   Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...