Search results
Results from the WOW.Com Content Network
A Leupold telescopic sight mounted on a dovetailed rifle receiver via two scope rings From left: A sketch of a cross section on a Zeiss rail and ring mount, both with a Picatinny rail interface. Scope mounts are rigid implements used to attach (typically) a telescopic sight or other types of optical sights onto a firearm.
Surveying equipment, rifle scopes, and related products are sold under the "Leupold" name, while water monitoring instrumentation, such as level and flow recorders, are marketed under the "Stevens" brand. [5] After World War II Leupold & Stevens began making gun scopes after Marcus Leupold failed to hit a deer with his rifle. His scope fogged ...
The mount is found on the left side of the rifle receiver, with machined cutouts for reduced weight and ease of installation; an example is the PSO-1 optical sight. Similar rails can also be found on rifles such as the Dragunov sniper rifle (SVD), the PSL rifle, the PKM as well as some AK series assault rifles from 1954 onwards. Since 1992 the ...
A rail system mounted on top of a SIG SG 550 A dovetail rail on a rifle receiver for mounting a sight. A rail integration system (RIS; also called a rail accessory system (RAS), rail interface system, rail system, mount, base, gun rail, or simply a rail [1]) is a generic term for any standardized attachment system for mounting firearm accessories via bar-like straight brackets (i.e. "rails ...
For example, with a typical Leupold brand 16 minute of angle (MOA) duplex reticle (similar to image B) on a fixed-power telescopic sight, the distance from post to post, between the heavier lines of the reticle spanning the center of the sight picture, is approximately 32 inches (810 millimeters) at 200 yards (180 m), or, equivalently ...
Compared to the Leupold mount, the Weaver rail is not as strong and cannot be adjusted for windage. [ 4 ] W.R. Weaver Co. became Weaver Optics, and was a subsidiary of Meade Instruments Corporation from 2002 to 2008, when it was on-sold to become part of Alliant Techsystems 's Security and Sporting division in Onalaska, Wisconsin.
It is similar in concept to the earlier commercial Weaver rail mount used to mount telescopic sights, but is taller and has wider slots at regular intervals along the entire length. The MIL-STD-1913 locking slot width is 0.206 in (5.23 mm). The spacing of slot centres is 0.394 in (10.01 mm) and the slot depth is 0.118 in (3.00 mm). [8]
The "long action" allows the rifle to be re-configured for dimensionally larger cartridges up to 3.340 inches (84.84 mm) in overall length. The M24 originally came tapped for the Leupold Ultra M3A 10×42mm fixed-power scope, which came with a circle-shaped mil-dot glass-etched reticle.