Search results
Results from the WOW.Com Content Network
Insulated pipes (called also preinsulated pipes or bonded pipe [1]) are widely used for district heating and hot water supply. They consist of a steel pipe called "service pipe", a thermal insulation layer and an outer casing. The insulation bonds the service pipe and the casing together.
The application of thermal pipe insulation introduces thermal resistance and reduces the heat flow. Thicknesses of thermal pipe insulation used for saving energy vary, but as a general rule, pipes operating at more-extreme temperatures exhibit a greater heat flow and larger thicknesses are applied due to the greater potential savings. [3]
By the 1870s all houses were constructed with cast iron gutters and down pipes. The Victorian gutter was an ogee, 115 mm in width, that was fitted directly to the fascia boards eliminating the need for brackets. Square and half-round profiles were also available.
A cross-linked polyethylene (PEX) pipe. Cross-linked polyethylene, commonly abbreviated PEX, XPE or XLPE, is a form of polyethylene with cross-links.It is used predominantly in building services pipework systems, hydronic radiant heating and cooling systems, domestic water piping, insulation for high tension (high voltage) electrical cables, and baby play mats.
They should not be confused with so-called valley gutters or valley flashings which occur at the non-parallel intersection of roof surfaces, typically at right angled internal corners of pitched roofs. Provision is made in the design of the gutter to have a rain flow to the outlet with a maximum slope of 1:200 and a minimum of 1:400.
In past centuries, when urban streets did not have sanitary sewers, street gutters were made deep enough to serve that purpose as well; responsibility for operation and maintenance of the dual-purpose street gutter was cooperatively shared between the local government and the inhabitants. [2] A now obsolete word meaning a street gutter is a kennel.
The layer of insulation and outer wrapping around a boiler shell, particularly that of a steam locomotive. In early practice this was usually wooden strips held by brass bands. Later and modern practice is to use asbestos insulation matting (or other less hazardous fibres) covered with rolled steel sheets.