Search results
Results from the WOW.Com Content Network
The 1915 textbook Practical Electric Wiring describes the construction of the Western Union splice; short tie and long tie. The short tie splice has it being formed after stripping the insulation from a pair of wires for several inches, each, crossing the wires left over right as shown in figure part A; then, a hooked cross (figure part B) is formed holding the crossing point of the two wires ...
The product which is used to make an eye splice is known as: Oval Sleeve, Figure 8 Sleeve, Hourglass Sleeve, Duplex Sleeve, Ferrule and Nicos. Correct installation is critical to the performance of the product; this includes utilizing the correct tool groove and/or die, number of presses/bites, press sequence and gauging.
It is typically used for light lines (e.g. the log-line) where a single splice would tend to come undone, the rope being frequently wet. [5] It makes a very strong knot. A cut splice is a join between two ropes, made by side splicing the ends slightly apart, to make an eye in the joined rope which lies shut when the rope is taut.
The eye splice is a method of creating a permanent loop (an "eye") in the end of a rope by means of rope splicing. The Flemish eye is a type of circular loop at the end of a thread. There are several techniques of creating the eye with its knot tied back to the line, rope or wire.
A marlinspike is used in working with wire rope, natural and synthetic lines, may be used to open shackles, and is made of metal. A fid is used to hold open knots and holes in canvas, and to separate the "lays" (or strands) of synthetic or natural rope for splicing. A variation of the fid, the gripfid, is used for ply-split braiding. The ...
Splice site of a copper wire. Cable sleeve (lead sleeve) for connecting paper-insulated wires Insulating sleeves. The splicing of copper wires happens in the following steps: The cores are laid one above the other at the junction. The core insulation is removed. The wires are wrapped two to three times around each other .
In stricter senses, the term wire rope refers to a diameter larger than 9.5 mm (3 ⁄ 8 in), with smaller gauges designated cable or cords. [1] Initially wrought iron wires were used, but today steel is the main material used for wire ropes. Historically, wire rope evolved from wrought iron chains, which had a record of mechanical failure.
Rope is constructed in a linear fashion, and must be spliced together before carriers are affixed. Splicing involves unwinding long sections of either end of the rope, and then winding each strand from opposing ends around the core. Sections of rope must be removed, as the strands overlap during the splicing process. [6]