enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tire code - Wikipedia

   en.wikipedia.org/wiki/Tire_code

   To take a common example, 195/55R16 would mean that the nominal width of the tire is approximately 195 mm at the widest point, the height of the side-wall of the tire is 55% of the width (107 mm in this example) and that the tire fits 16-inch-diameter (410 mm) rims. The code gives a direct calculation of the theoretical diameter of the tire.

3. Tire uniformity - Wikipedia

   en.wikipedia.org/wiki/Tire_uniformity

   Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...

4. Uniform Tire Quality Grading - Wikipedia

   en.wikipedia.org/wiki/Uniform_Tire_Quality_Grading

   These represent the tire's resistance to the generation of heat at speed. Tires graded A effectively dissipate heat up to a maximum speed that is greater than 115 mph. B rates at a maximum between 100 mph and 115 mph. C rates at a maximum of between 85 mph to 100 mph. Tires that cannot grade up to C or higher cannot be sold in the US. [9]

5. Here’s What Those Numbers on Your Tires Mean - AOL

   www.aol.com/lifestyle/those-numbers-tires-mean...

   For premium support please call: 800-290-4726 more ways to reach us

6. Tyre label - Wikipedia

   en.wikipedia.org/wiki/Tyre_label

   The wet grip index (WGI) is calculated from the results of two tests specified in the regulations. The first test measures the maximum achievable average deceleration of a vehicle as it slows from 85 ± 2 km/h (52.8 mph) to 20 ± 2 km/h (12.4 mph). The second test (the "skid trailer" test) is usually performed using a tow vehicle and trailer.

7. Plus sizing - Wikipedia

   en.wikipedia.org/wiki/Plus_sizing

   Plus sizing is the practice of replacing an automotive wheel with one of a larger diameter fitted with a new tire of lower aspect ratio so that the new tire has close to the same diameter and circumference as the original tire to minimize any changes in speedometer accuracy, torque and traction control, while reducing sidewall flex and (generally) increasing cornering ability.

8. Tire manufacturing - Wikipedia

   en.wikipedia.org/wiki/Tire_manufacturing

   Tire balance measurement is a test where the tire is automatically placed on wheel halves, rotated at a high speed and measured for imbalance. Large commercial truck/bus tires, as well as some passenger and light truck tires, are inspected by X-ray or magnetic induction based inspection machines, that can penetrate the rubber to analyze the ...

9. Racing slick - Wikipedia

   en.wikipedia.org/wiki/Racing_slick

   The first drag racing slick was developed by M&H Tires (Marvin & Harry Tires) in the early 1950s. It was the only company in the world that produced and sold original drag racing tyres. Drag racing slicks vary in size, from slicks used on motorcycles to very wide ones used on "top fuel" dragsters.