Search results
Results from the WOW.Com Content Network
An officer’s tool (also known as an A-tool, rex tool, or lock puller) is a forcible entry device used by firefighters and other first responders. Officer’s tools are designed to completely remove cylindrical locks from doors without causing major structural damage, allowing for direct access to the internal locking mechanism.
A slim jim (more technically known as a lockout tool) is a thin strip of metal (usually spring steel) roughly 60 centimetres (24 in) long and about 2–4 centimetres (0.79–1.57 in) wide originally marketed under that name by HPC Inc., a manufacturer and supplier of specialty locksmithing tools.
Utilizing a breaching tool is unnecessary if the door is unlocked and easy to open. [5] [3] [6] [1] If the door is locked, breachers can attempt to force inward-opening doors with a strong kick. The breacher will aim to hit the door near the locking mechanism, but not kick the doorknob itself as one can easily twist an ankle doing so. [7]
In 1961, at a meeting in Scottsdale, Arizona, the Committee on Grade Simplification and Standardization agreed to what is now the current U.S. standard: in part, the dressed size of a 1-inch (nominal) board was fixed at 3 ⁄ 4 inch; while the dressed size of 2 inch (nominal) lumber was reduced from 1 + 5 ⁄ 8 inch to the current 1 + 1 ⁄ 2 inch.
CECO Environmental Corp. is a company founded in 1966 and now is based in Dallas, TX. The company provides air pollution control technology, products and services for various industries, including aerospace , brick, cement, steel, printing, food, foundries, utilities, woodworking, chemical processing, glass, automotive, ethanol ...
Cleco (Cleko) fasteners on an aircraft wing. A cleco, also spelled generically cleko, is a temporary fastener developed by the Cleveland Pneumatic Tool Company. [1] Widely used in the manufacture and repair of aluminum-skinned aircraft, it is used to temporarily fasten sheets of material together, or to hold parts such as stiffeners, frames etc together, before they are permanently joined.
Door clearances at the door edge of the door frame (Wood Door), on the pull side of the door, do not exceed clearances listed in 4.8.4 (the clearance under the bottom of the door shall be a maximum of 3/4") and 6.3.1 (top & edges 1/8") Metal door (top & edges up to 3/16")
The patent also used the keys and slots and a tail on the tool shank to prevent the tool shank from falling out of a horizontal mill's spindle while the operator connected the drawbar. [12] ANSI B5.18-1972 specifies some essential dimensions for milling machine spindles and tool shanks using taper sizes 30, 40, 45, 50, 60. [13]