Search results
Results from the WOW.Com Content Network
If a gaseous emission sample is analyzed and found to contain water vapor and a pollutant concentration of say 40 ppmv, then 40 ppmv should be designated as the "wet basis" pollutant concentration. The following equation can be used to correct the measured "wet basis" concentration to a "dry basis" concentration: [3]
Dusts also have upper and lower explosion limits, though the upper limits are hard to measure and of little practical importance. Lower flammability limits for many organic materials are in the range of 10–50 g/m 3, which is much higher than the limits set for health reasons, as is the case for the LEL of many gases and vapours. Dust clouds ...
The conversion equations depend on the temperature at which the conversion is wanted (usually about 20 to 25 °C). At an ambient sea level atmospheric pressure of 1 atm (101.325 kPa or 1.01325 bar), the general equation is:
Any mixture of methane and air will therefore lie on the straight line between pure methane and pure air – this is shown as the blue air-line. The upper and lower flammability limits of methane in air are located on this line, as shown (labelled UEL and LEL, respectively). The stoichiometric combustion of methane is: CH 4 + 2O 2 → CO 2 + 2H ...
This chemical reaction article is a stub. You can help Wikipedia by expanding it.
1400 ppm: 141797 (10% Lower explosive limit LEL) 72-43-5: 1306: Methoxychlor: 5000 mg/m 3-72435, carcinogenic substance 79-20-9: 0507: Methyl acetate: 9393 mg/m 3: 3100 ppm: 79209 (10% Lower explosive limit LEL) 74-99-7: 0560: Methyl acetylene: 2788 mg/m 3: 1700 ppm: 74997 (10% Lower explosive limit LEL) 59355-75-8-Methyl acetylene-propadiene ...
Its units are in parts per million (ppm) for gases and in milligrams per cubic meter (mg/m 3) for particulates such as dust, smoke and mist. The basic formula for converting between ppm and mg/m 3 for gases is ppm = (mg/m^3) * 24.45 / molecular weight. This formula is not applicable to airborne particles.
Flammability diagram, green dotted line shows safe purging of an air-filled vessel, first with nitrogen, then with methane, to avoid the flammable region. The limiting oxygen concentration is shown in the lower right of the diagram.