Search results
Results from the WOW.Com Content Network
However, in this case two complete differentials are used, one for each track, and the idlers are controlled not by a brake, but a second power shaft, the steering shaft. [2] Normally the steering shaft is connected to the engine directly, instead of the output from the transmission. This means it spins at a relatively narrow range of RPM ...
Another version of wind vane self steering on sail boats is known as the vertical axis vane and usually, because of the inferior steering force output compared to servo pendulum devices it makes use of a trim tab hung off the rudder to control the course of the boat. The vane spins at right angles to the ground and can lock to the trim tab in ...
The shaft power from each can either go directly to the propeller, pump jet or other mechanism, or it goes through some form of transmission; mechanical, electrical or hydraulic. In the 1800s, steam was one of the main power sources for marine propulsion.
The outdrive resembles the bottom half of an outboard motor and is composed of two sub-units: an upper containing a driveshaft connected through the transom to an engine which transmits power to a 90-degree-angle gearbox; and the lower containing a vertical driveshaft receiving power from the upper unit gearbox, transmitted through another 90 ...
Generally, a rudder is "part of the steering apparatus of a boat or ship that is fastened outside the hull, " denoting all types of oars, paddles, and rudders. [1] More specifically, the steering gear of ancient vessels can be classified into side-rudders and stern-mounted rudders, depending on their location on the ship.
This naturally leaves a small gap between the sternpost and the rudder, into which stray items like kelp and rope can catch, causing drag and threatening the security of the vessel's steering. In ships such as Mary Rose, the skeg is a very small feature; a tapered extension of the keel below the leading edge of the
The higher the angular momentum, the greater the resisting force of the gyro to external torque (in this case more ability to cancel boat roll). A gyroscope has three axes: a spin axis, an input axis, and an output axis. The spin axis is the axis about which the flywheel is spinning and is vertical for a boat gyro.
The jacking gear motor is generally designed to rotate the shaft at approximately 1/10 rpm. Most jacking gear motors are rated at 5hp. The jacking gear motor assembly applies power and torque to the reduction gear by a flexible coupling or clutch that can freely engage and disengage to the high-pressure pinion (driving gear).