Search results
Results from the WOW.Com Content Network
In computing, a non-maskable interrupt (NMI) is a hardware interrupt that standard interrupt-masking techniques in the system cannot ignore. It typically occurs to signal attention for non-recoverable hardware errors. Some NMIs may be masked, but only by using proprietary methods specific to the particular NMI.
In computing, an inter-processor interrupt (IPI), also known as a shoulder tap, is a special type of interrupt by which one processor may interrupt another processor in a multiprocessor system if the interrupting processor requires action from the other processor. Actions that might be requested include:
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
The detection of an NMI or IRQ signal, as well as the execution of a BRK instruction, will cause the same overall sequence of events, which are, in order: [1] [3]. The processor completes the current instruction and updates registers or memory as required before responding to the interrupt.
The LPC1100(X)L-series consists of three subseries: LPC111x, LPC111xL, and LPC111xXL. The LPC111xL and LPC111xXL include the power profiles, a windowed watchdog timer, and a configurable open-drain mode. The LPC1110XL adds a Non-Maskable Interrupt (NMI) and 256-byte page flash erase function.
The IRR specifies which interrupts are pending acknowledgement, and is typically a symbolic register which can not be directly accessed. The ISR register specifies which interrupts have been acknowledged, but are still waiting for an end of interrupt (EOI). The IMR specifies which interrupts are to be ignored and not acknowledged.
An interrupt control register, or ICR, is a hardware register in a computer chip used to configure the chip to generate interrupts—to raise a signal on an interrupt line—in response to some event occurring within the chip or a circuit connected to the chip. [1] [2]
The interrupt descriptor table (IDT) is a data structure used by the x86 architecture to implement an interrupt vector table. The IDT is used by the processor to determine the memory addresses of the handlers to be executed on interrupts and exceptions .