enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

3. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

4. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

5. Grinnell Mechanical Products - Wikipedia

   en.wikipedia.org/wiki/Grinnell_Mechanical_Products

   Grinnell grooved products include grooved couplings, grooved fittings, mechanical tees, valves, circuit balancing valves, copper systems, stainless steel systems, plain end systems, HDPE systems, PVC systems, G-PRESS systems, gaskets and spare parts, and preparation equipment, as well as accessories, such as strainers, tee strainers, suction diffusers, dielectric waterway transition fittings ...

6. Solder ring fitting - Wikipedia

   en.wikipedia.org/wiki/Solder_ring_fitting

   To obtain functional joints, the inside of the fitting and the outside of the copper pipe are cleaned using steel wool or cleaning tape, flux paste is applied, the pipe is inserted into the fitting and heat is applied from a portable butane torch or propane torch until a ring of solder shows at the edges of the fitting.

7. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   The history of copper pipe is similar. In the 1930s, the pipe was designated by its internal diameter and a 1 ⁄ 16-inch (1.6 mm) wall thickness. Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings.