Search results
Results from the WOW.Com Content Network
A variable in an experiment which is held constant in order to assess the relationship between multiple variables [a], is a control variable. [2] [3] A control variable is an element that is not changed throughout an experiment because its unchanging state allows better understanding of the relationship between the other variables being tested. [4]
In this case, the control variables may be wind speed, direction and precipitation. If the experiment were conducted when it was sunny with no wind, but the weather changed, one would want to postpone the completion of the experiment until the control variables (the wind and precipitation level) were the same as when the experiment began.
To control for nuisance variables, researchers institute control checks as additional measures. Investigators should ensure that uncontrolled influences (e.g., source credibility perception) do not skew the findings of the study. A manipulation check is one example of a control check. Manipulation checks allow investigators to isolate the chief ...
A scientific control is an experiment or observation designed to minimize the effects of variables other than the independent variable (i.e. confounding variables). [1] This increases the reliability of the results, often through a comparison between control measurements and the other measurements. Scientific controls are a part of the ...
An optimal control is a set of differential equations describing the paths of the control variables that minimize the cost function. The optimal control can be derived using Pontryagin's maximum principle (a necessary condition also known as Pontryagin's minimum principle or simply Pontryagin's principle), [8] or by solving the Hamilton ...
A variable may be thought to alter the dependent or independent variables, but may not actually be the focus of the experiment. So that the variable will be kept constant or monitored to try to minimize its effect on the experiment. Such variables may be designated as either a "controlled variable", "control variable", or "fixed variable".
Departure of such a variable from its setpoint is one basis for error-controlled regulation using negative feedback for automatic control. [3] A setpoint can be any physical quantity or parameter that a control system seeks to regulate, such as temperature, pressure, flow rate, position, speed, or any other measurable attribute.
In control engineering and other areas of science and engineering, state variables are used to represent the states of a general system. The set of possible combinations of state variable values is called the state space of the system. The equations relating the current state of a system to its most recent input and past states are called the ...