Search results
Results from the WOW.Com Content Network
Mode 3/A is often combined with Mode C to provide altitude information as well. [2] C: Provides the aircraft's pressure altitude and is usually combined with Mode 3/A to provide a combination of a 4-digit octal code and altitude as Mode 3 A/C, often referred to as Mode A and C [2] 4: Provides a 3-pulse reply, delay is based on the encrypted ...
Gillham code is a zero-padded 12-bit binary code using a parallel nine- [1] to eleven-wire interface, [2] the Gillham interface, that is used to transmit uncorrected barometric altitude between an encoding altimeter or analog air data computer and a digital transponder. It is a modified form of a Gray code and is sometimes referred to simply as ...
Identification, friend or foe ( IFF) is a combat identification system designed for command and control. It uses a transponder that listens for an interrogation signal and then sends a response that identifies the broadcaster. IFF systems usually use radar frequencies, but other electromagnetic frequencies, radio or infrared, may be used. [ 1]
The two octatonic scales on C. An octatonic scale is any eight- note musical scale. However, the term most often refers to the ancohemitonic symmetric scale composed of alternating whole and half steps, as shown at right. In classical theory (in contrast to jazz theory ), this symmetrical scale is commonly called the octatonic scale (or the ...
Octal ( base 8) is a numeral system with eight as the base . In the decimal system, each place is a power of ten. For example: In the octal system, each place is a power of eight. For example: By performing the calculation above in the familiar decimal system, we see why 112 in octal is equal to in decimal.
For mode A, each digit in the transponder code (A, B, C, or D) may be a number from zero to seven. These octal digits are transmitted as groups of three pulses each, the A slots reserved for the first digit, B for the second, and so on. In a mode C reply, the altitude is encoded by a Gillham interface, Gillham code, which uses Gray code. The ...
chmod. In Unix and Unix-like operating systems, chmod is the command and system call used to change the access permissions and the special mode flags (the setuid, setgid, and sticky flags) of file system objects ( files and directories ).
Serial Peripheral Interface ( SPI) is a de facto standard (with many variants) for synchronous serial communication, used primarily in embedded systems for short-distance wired communication between integrated circuits . SPI uses a master–slave architecture, described here with the terms "main" and "sub", [ note 2] [ 1] where one [ note 3 ...