Search results
Results from the WOW.Com Content Network
Cathodic arc deposition or Arc-PVD is a physical vapor deposition technique in which an electric arc is used to vaporize material from a cathode target. The vaporized material then condenses on a substrate, forming a thin film. The technique can be used to deposit metallic, ceramic, and composite films.
The coating temperature has an effect on the bath conductivity and deposited film conductivity, which increases as temperature increases. Temperature also has an effect on the viscosity of the deposited film, which in turn affects the ability of the deposited film to release the gas bubbles being formed.
Electroplating, also known as electrochemical deposition or electrodeposition, is a process for producing a metal coating on a solid substrate through the reduction of cations of that metal by means of a direct electric current.
Mill scale is a complex oxide that contains around 70% iron with traces of nonferrous metals and alkaline compounds. Reduced iron powder may be obtained by conversion of mill scale into a single highest oxide i.e. hematite (Fe 2 O 3) followed by reduction with hydrogen.
It can be used for electrochemical deposition of thin films or for determining suitable reduction potential range of the ions present in electrolyte for electrochemical deposition. [13] CV can also be used to determine the electron stoichiometry of a system, the diffusion coefficient of an analyte, and the formal reduction potential of an ...
The cathodic current is balanced by the anodic current. This ongoing current in both directions is called the exchange current density. When the potential is set more negative than the formal potential, the cathodic current is greater than the anodic current. Written as a reduction, cathodic current is positive.
The PVD process can be carried out at lower deposition temperatures and without corrosive products, but deposition rates are typically lower. Electron-beam physical vapor deposition, however, yields a high deposition rate from 0.1 to 100 μm/min at relatively low substrate temperatures, with very high material utilization efficiency. The ...
The unshaded bars indicate the location on the chart of those steels when in acidic/stagnant water ( like in the bilge ), where crevice-corrosion happens. Notice how the *same* steel has much different galvanic-series location, depending on the electrolyte it's in, making prevention of corrosion .. more difficult.