Search results
Results from the WOW.Com Content Network
High-efficiency all-electric refrigerant compressors for air conditioning are starting to be used, especially in hybrid or all-electric vehicles. The cigarette lighter receptacle serves as a de facto standard for use of portable 12 volt equipment in or near an automobile, it is sometimes used with car charger to power devices with batteries.
Compressed air is the most common power source for impact wrenches, [citation needed] providing a low-cost design with the best power-to-weight ratio.A normal vane motor is almost always used, usually with four to seven vanes, and various lubrication systems, the most common of which uses oiled air, while others may include special oil passages routed to the parts that need it and a separate ...
A power tool is a tool that is actuated by an additional power source and mechanism other than the solely manual labor used with hand tools. The most common types of power tools use electric motors. Internal combustion engines and compressed air are also commonly used. Tools directly driven by animal power are not
The SAE discussed an increased automobile standard voltage as early as 1988. [3]In 1994, at the initiative of Daimler-Benz, the first "Workshop on Advanced Architectures for Automotive Electrical Distribution Systems" was held at the Massachusetts Institute of Technology Laboratory for Electromagnetic and Electronic Systems (MIT/LEES) in Cambridge, Massachusetts USA. with the aim of defining ...
Automotive tool manufacturers (24 P) Pages in category "Automotive tools" The following 7 pages are in this category, out of 7 total. This list may not reflect recent ...
A manual impact driver (for use with hammer) with screwdriver bits and adapters An impact driver is a tool that delivers a strong, sudden rotational force and forward thrust. The force can be delivered either by striking with a hammer in the case of manual impact drivers, or mechanically in the case of powered impact drivers.
Sandy Munro is an automotive engineer who specializes in machine tools and manufacturing. He started as a toolmaker at the Valiant Machine & Tool company – a General Motors supplier in Windsor . In 1978, he joined the Ford Motor Company where he improved methods of engine assembly.
An automotive thermoelectric generator (ATEG) is a device that converts some of the waste heat of an internal combustion engine (IC) into electricity using the Seebeck Effect. A typical ATEG consists of four main elements: A hot-side heat exchanger , a cold-side heat exchanger, thermoelectric materials , and a compression assembly system.