Search results
Results from the WOW.Com Content Network
Face Veneer thickness-- For any three-ply construction, which applies to 3 and 4 mm material, each face veneer shall be not thinner than 1/8 of the total thickness of veneers assembled dry. Since the dry thicknesses of the boards are 3.6 and 4.6 respectively, we can assume that, for these thicknesses only, the face veneers will be as follows:
Aircraft plywood is available in thicknesses of 1 ⁄ 8 inch (3 mm) (3-ply construction) and upwards; typically aircraft plywood uses veneers of 0.5 mm (approx 1/64 in) thickness although much thinner veneers such as 0.1 mm are also used in construction of some of the thinner panels.
This 5 ⁄ 16 inch (7.9 mm) thick cement board is designed as an underlayment for tile floors. These are 3-by-5-foot (91 by 152 cm) sheets. These are 3-by-5-foot (91 by 152 cm) sheets. A cement board is a combination of cement and reinforcing fibers formed into sheets, of varying thickness that are typically used as a tile backing board. [ 1 ]
In the Americas, two-bys (2×4s, 2×6s, 2×8s, 2×10s, and 2×12s), named for traditional board thickness in inches, along with the 4×4 (89 mm × 89 mm), are common lumber sizes used in modern construction. They are the basic building blocks for such common structures as balloon-frame or platform-frame housing.
Wood flooring is a popular feature in many houses. Engineered wood flooring consists of two or more layers of wood adhered together to form a plank. Typically, engineered wood flooring uses a thin layer of a more expensive wood bonded to a core constructed from cheaper wood. The increased stability of engineered wood is achieved by running each ...
The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist .
Plywood sheet siding is sometimes used on inexpensive buildings, sometimes with grooves to imitate vertical shiplap siding. One example of such grooved plywood siding is the type called Texture 1–11, T1-11, or T111 ("tee-one-eleven").
For hardwood flooring, the test usually requires an 80 mm × 150 mm (3 in × 6 in) sample with a thickness of at least 6–8 mm, and the most commonly used test is the ASTM D1037. When testing wood in lumber form, the Janka test is always carried out on wood from the tree trunk (known as the heartwood), and the standard sample (according to ...