Search results
Results from the WOW.Com Content Network
The emergence of the muons is caused by the collision of cosmic rays with the upper atmosphere, after which the muons reach Earth. The probability that muons can reach the Earth depends on their half-life, which itself is modified by the relativistic corrections of two quantities: a) the mean lifetime of muons and b) the length between the upper and lower atmosphere (at Earth's surface).
is the time between two events as measured in the moving reference frame in which they occur at the same place (e.g. two ticks on a moving clock); it is called the proper time between the two events; t is the time between these same two events, but as measured in the stationary reference frame;
where Δt is the time interval between two co-local events (i.e. happening at the same place) for an observer in some inertial frame (e.g. ticks on their clock), known as the proper time, Δt′ is the time interval between those same events, as measured by another observer, inertially moving with velocity v with respect to the former observer ...
For example, ordered pairs of events (A, B) and (B, C) could each be separated by slightly more than 1 Planck time: this would produce a measurement limit of 1 Planck time between A and B or B and C, but a limit of 3 Planck times between A and C. [citation needed] The chronon is a quantization of the evolution in a system along its world line.
A straight line connecting these two events is always the time axis of a possible observer for whom they happen at the same place. Two events which can be connected just with the speed of light are called lightlike. In principle a further dimension of space can be added to the Minkowski diagram leading to a three-dimensional representation.
The Lorentz-transform calculation above uses a definition of extended-simultaneity (i.e. of when and where events occur at which you were not present) that might be referred to as the co-moving or "tangent free-float-frame" definition. This definition is naturally extrapolated to events in gravitationally-curved spacetimes, and to accelerated ...
The long interval can be measured with a counter. The counter information is supplemented with two time interpolators: one interpolator measures the (short) interval between the start event and a following clock event, and the second interpolator measure the interval between the stop event and a following clock event.
Table showing quantitative relationships between common units of time A unit of time is any particular time interval, used as a standard way of measuring or expressing duration. The base unit of time in the International System of Units (SI), and by extension most of the Western world , is the second , defined as about 9 billion oscillations of ...