Search results
Results from the WOW.Com Content Network
A rabbet. A rabbet (American English) or rebate (British English) is a recess or groove cut into the edge of a piece of machinable material, usually wood.When viewed in cross-section, a rabbet is two-sided and open to the edge or end of the surface into which it is cut.
A wood rabbet plane A rabbet or rebate. The rebate plane (British English) or rabbet plane (American English) is a hand plane designed for cutting rebates/rabbets in wood. It's a simple tool used in many Western countries with hundreds of years of history. It was in use in England at least as early as the 11th century. [citation needed]
A through dado (left) and a stopped dado. A dado (US and Canada, / ˈ d eɪ d oʊ /), housing (UK) or trench (Europe) is a slot or trench cut into the surface of a piece of machinable material, usually wood.
Tongue and groove: Tongue and groove joints are typically used for large surfaces such as a series of wooden panels on a wall or a table top. Dovetail joint: This joint is typically used for the corners of boxes. Rabbet: A rabbet joint is one of the simplest joints used on the show.
Mortise and tenon joints are strong and stable joints that can be used in many projects. They connect by either gluing or friction-fitting into place. The mortise and tenon joint also gives an attractive look. One drawback to this joint is the difficulty in making it because of the precise measuring and tight cutting required.
Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm (3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm (3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [1] The rabbet allows the boards to overlap in this area.
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
Joint Image Description Butt joint: The end of a piece of wood is butted against another piece of wood. This is the simplest and weakest joint. Of those, there is the a) T-butt, b) end-to-end butt, c) Miter butt and d) edge-to-edge butt. Lap joint: The end of a piece of wood is laid over and connected to another piece of wood.