Search results
Results from the WOW.Com Content Network
The second method involves introducing a short piece of rope of the same type as the main rope, and cutting that instead. This can be accomplished by many sleight of hand tricks but attaching it to the main rope disguised as the loop of a knot is the most common method. When the performer removes the knot, the original rope is completely uncut. [1]
A 3-dimensional rendering of the ribbon knot , showing the ribbon property. In the mathematical area of knot theory, a ribbon knot is a knot that bounds a self-intersecting disk with only ribbon singularities. Intuitively, this kind of singularity can be formed by cutting a slit in the disk and passing another part of the disk through the slit.
The discovery of all possible ways to tie a tie depends on a mathematical formulation of the act of tying a tie. In their papers (which are technical) and book (which is for a lay audience, apart from an appendix), the authors show that necktie knots are equivalent to persistent random walks on a triangular lattice, with some constraints on how the walks begin and end.
A constrictor knot prepared for tightening using two metal rods and marlinespike hitches. The constrictor knot is appropriate for situations where secure temporary or semi-permanent binding is needed. Made with small-stuff it is especially effective, as the binding force is concentrated over a smaller area. When tying over soft material such as ...
The lacing begins and ends with a whipping or other knot to secure the free ends. Wraps are spaced relative to the overall harness diameter to maintain the wiring in a tight, neat bundle, and the ends are then neatly trimmed.
As mentioned earlier, this knot can replace the figure-eight knot when tying into a climbing harness by tying a regular bowline knot and then re-threading it, such as is done with a figure eight knot. However, it is critical to use a strong backup knot with plenty of tail beyond the knot, as the knot may untie during long climbs. The advantage ...
Tie an overhand knot at the end of a rope but do not tighten the knot down. Pass the end of the line through the loop created by the first overhand knot. Tighten the knot down while sliding it into place at the end of the line. Be sure to leave some tail sticking out from the end of the knot. [7] [8]
Close-up of a shoelace knot. The shoelace knot, or bow knot, is commonly used for tying shoelaces and bow ties. The shoelace knot is a doubly slipped reef knot formed by joining the ends of whatever is being tied with a half hitch, folding each of the exposed ends into a loop and joining the loops with a second half hitch. The size of the loops ...