Search results
Results from the WOW.Com Content Network
Graham's Line Identification Tone System (GLITS) is a test signal for stereo systems devised by BBC TV Sound Supervisor and Fellow of the IPS Graham Haines in the mid-1980s. It comprises a 1 kHz tone at 0 dBu (-18 dBFS ) on both channels, with interruptions which identify the channels.
In telecommunication, a standard test tone is a pure tone with a standardized level generally used for level alignment of single links and of links in tandem. [1]For standardized test signal levels and frequencies, see MIL-STD-188-100 for United States Department of Defense (DOD) use, and the Code of Federal Regulations Title 47, part 68 for other Government agencies.
From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...
The measured curves for pure tones, for instance, are different from those for random noise. The ear also responds less well to short bursts, below 100 to 200 ms, than to continuous sounds [ 1 ] such that a quasi-peak detector has been found to give the most representative results when noise contains click or bursts, as is often the case for ...
The subwoofers' tuning ports were blocked and their input cards were altered. The modified cabinets were positioned in an open ring configuration, in four stacks, with each stack containing three subwoofers. Test signals were generated by a SIM 3 audio analyzer, with its software modified to produce infrasonic tones.
Before the bass management system, there is a LFE channel. After the bass management system, there is a subwoofer signal. A common misunderstanding is the belief that the LFE channel is the subwoofer channel. The bass management system may direct bass to one or more subwoofers (if present) from any channel, not just from the LFE channel. Also ...
Black & Lane's Ident Tones for Surround (BLITS) is a way of keeping track of channels in a mixed surround-sound, stereo, and mono world. [1] It was developed by Martin Black and Keith Lane of Sky TV London in 2004. BLITS is used by Sky, the BBC and other European and US broadcasters to identify and lineup 5.1 broadcast circuits.
Positioning is best done by moving the mic from side to side for maximum response on a 1 kHz tone, then a 3 kHz tone, then a 10 kHz tone. While the very best modern speakers can produce a frequency response flat to ±1 dB from 40 Hz to 20 kHz in anechoic conditions, measurements at 2 m in a real listening room are generally considered good if ...