enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.

3. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A pin chuck is a specialized chuck designed to hold small drills (less than 1 mm (0.039 in) in diameter) that could not be held securely in a normal drill chuck. The drill is inserted into the pin chuck and tightened; the pin chuck has a shaft which is then inserted into the larger drill chuck to hold the drill securely. Pin chucks are also ...

4. Spindle (tool) - Wikipedia

   en.wikipedia.org/wiki/Spindle_(tool)

   A machine tool may have several spindles, such as the headstock and tailstock spindles on a bench lathe. The main spindle is usually the biggest one. References to "the spindle" without further qualification imply the main spindle. Some machine tools that specialize in high-volume mass production have a group of 4, 6, or even more main spindles.

5. Magnetic drilling machine - Wikipedia

   en.wikipedia.org/wiki/Magnetic_drilling_machine

   A morse taper 3 arbor equipped magnetic drill machine using taper shank drill bits. The arbor or chuck on a magnetic drill is attached to the motor. It is a type of clamp used to attach the core drills. There are mainly two types of chuck available for the magnetic drill, industrial arbor (manual tightening) and quick change drill chucks. The ...

6. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   The triangle shank is almost always made by machining three flats on round bar stock. It is intended as a minor modification of a straight shank, still allowing it to be held in a 3-jaw drill chuck, but allowing higher torque transmission and limited slipping. Can be held in a drill chuck; High torque transmission; Moderately accurate centering

7. Lathe center - Wikipedia

   en.wikipedia.org/wiki/Lathe_center

   Dead center (the conical piece) mounted in the spindle of a lathe and being used to support a workpiece being driven by a carrier setup. A lathe center, often shortened to center, is a tool that has been ground to a point to accurately position a workpiece on an axis. They usually have an included angle of 60°, but in heavy machining ...