Search results
Results from the WOW.Com Content Network
Further improvements can be made to the selectivity of MEKC by adding chiral selectors or chiral surfactants to the system. Unfortunately, this technique is not suitable for protein analysis because proteins are generally too large to partition into a surfactant micelle and tend to bind to surfactant monomers to form SDS-protein complexes.
A micelle (/ m aɪ ˈ s ɛ l /) or micella (/ m aɪ ˈ s ɛ l ə /) (pl. micelles or micellae, respectively) is an aggregate (or supramolecular assembly) of surfactant amphipathic lipid molecules dispersed in a liquid, forming a colloidal suspension (also known as associated colloidal system). [4] A typical micelle in water forms an aggregate ...
Schematic of a micellar solution showing spherical micelles distributed in water (solvent) and having no long-range positional order. In colloid science, a micellar solution consists of a dispersion of micelles (small particles) in a solvent (most usually water).
Schematic diagram of a micelle – the lipophilic tails of the surfactant ions remain inside the oil because they interact more strongly with oil than with water. The polar "heads" of the surfactant molecules coating the micelle interact more strongly with water, so they form a hydrophilic outer layer that forms a barrier between micelles. This ...
To decrease free energy of the system the surfactant is precipitated out. CMC is determined by establishing inflection points for pre-determined surface tension of surfactants in solution. Plotting the inflection point against the surfactant concentration will provide insight into the critical micelle concentration by showing stabilization of ...
The amphiphiles' hydrocarbon tails are contained on the inside of the micelle and hence the polar-apolar interface of the aggregates has a positive mean curvature, by definition (it curves away from the polar phase). The first pure surfactant system found to exhibit three different type I (oil-in-water) micellar cubic phases was observed in the ...
CM is the concentration of the micelle in the mobile phase (total surfactant concentration - critical micelle concentration) A plot of 1/k¢ verses CM gives a straight line in which KSW can be calculated from the intercept and KMW can be obtained from the ratio of the slope to the intercept. Finally, KSM can be obtained from the ratio of the ...
The instrumentation needed to perform capillary electrophoresis is relatively simple. A basic schematic of a capillary electrophoresis system is shown in figure 1. The system's main components are a sample vial, source and destination vials, a capillary, electrodes, a high voltage power supply, a detector, and a data output and handling device ...