Search results
Results from the WOW.Com Content Network
When using a path length that is shorter than 10mm, the resultant OD will be reduced by a factor of 10/path length. Using the example above with a 3 mm path length, the OD for the 100 μg/mL sample would be reduced to 0.6. To normalize the concentration to a 10mm equivalent, the following is done: 0.6 OD X (10/3) * 50 μg/mL=100 μg/mL
To create the solution, 11.6 g NaCl is placed in a volumetric flask, dissolved in some water, then followed by the addition of more water until the total volume reaches 100 mL. The density of water is approximately 1000 g/L and its molar mass is 18.02 g/mol (or 1/18.02 = 0.055 mol/g).
U/L or ng/mL: 0.17 [58] 1.17 [58] μkat/L: CK-MB: 0: 3, [15] 3.8, [5] 5 [54] ng/mL or μg/L [5] Myoglobin: Female: 1 [59] 66 [59] ng/mL or μg/L: Male: 17 [59] 106 [59] Cardiac troponin T (low sensitive) 0.1 [7] ng/mL: 99th percentile cutoff: Cardiac troponin I (high sensitive) 0.03 [7] ng/mL 99th percentile cutoff: Cardiac troponin T (high ...
The conversion equations depend on the temperature at which the conversion is wanted (usually about 20 to 25 degrees Celsius). At an ambient air pressure of 1 atmosphere (101.325 kPa), the general equation is: = / ()
Section 3.8 introduces atomic units and gives a table of atomic units of various physical quantities and the conversion factor to the SI units. Section 7.3(v) gives a concise but clear tutorial on practical use of atomic units, in particular how to understand equations "written in atomic units".
For example, the conversion factor between a mass fraction of 1 ppb and a mole fraction of 1 ppb is about 4.7 for the greenhouse gas CFC-11 in air (Molar mass of CFC-11 / Mean molar mass of air = 137.368 / 28.97 = 4.74). For volume fraction, the suffix "V" or "v" is sometimes appended to the parts-per notation (e.g. ppmV, ppbv, pptv).
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
A solution with 1 g of solute dissolved in a final volume of 100 mL of solution would be labeled as "1%" or "1% m/v" (mass/volume). This is incorrect because the unit "%" can only be used for dimensionless quantities. Instead, the concentration should simply be given in units of g/mL.